Mazda Mazda6 - Page 629

PROPELLER SHAFT
L–13
L
5. Measure the bearing cup groove width, and select
a new snap ring that thickness is same as the
groove to install.
Snap ring thickness
mm {in}
6. Fit the snap ring to the yoke by lightly tapping
around the yoke with a copper hammer.
7. Verify that there is no play in the spider.
8. Align the mark made during disassembly, and
assemble the propeller shaft and yoke.
9. Install the bearing cup and snap ring to the yoke
as step 1 through 6.
10. Improve the fit by lightly tapping around the
universal joint with a plastic hammer.
11. Inspect the universal joint play and movement.
(See L–14 PROPELLER SHAFT INSPECTION.)
End Of Sie
Snap ring
Part number Thickness
T010 25 071 1.21 {0.0476}
T010 25 071B 1.22 {0.0480}
T010 25 072 1.23 {0.0484}
T010 25 072B 1.24 {0.0488}
T010 25 073 1.25 {0.0492}
T010 25 073B 1.26 {0.0496}
T010 25 074 1.27 {0.0500}
T010 25 074B 1.28 {0.0504}
T010 25 075 1.29 {0.0508}
T010 25 075B 1.30 {0.0512}
T010 25 076 1.31 {0.0516}
T010 25 076B 1.32 {0.0520}
T010 25 077 1.33 {0.0524}
T010 25 077B 1.34 {0.0528}
T010 25 078 1.35 {0.0532
T010 25 078B 1.36 {0.0535}
T010 25 079 1.37 {0.0539}
T010 25 079B 1.38 {0.0543}
T010 25 081 1.39 {0.0547}
A6E6110W012
A6E6110W013
MARK
A6E6110W014