N–18
ENGINE SPEED SENSING POWER STEERING
Power Steering Oil Pump Component Disassembly Note
1. Secure the power pressure oil pump using the SST.
Caution
• Use the SST to prevent damage to the
pump when securing it in a vise.
Clip Disassembly Note
1. Lift up the clip tab using a flathead screwdriver.
2. Remove the clip by pushing it with a flathead
screwdriver and a hammer as shown in the figure.
Vane Assembly Note
1. Place the vanes in the rotor with the rounded
edges contacting the cam.
10 Rear pump body
(See N–19 Rear Pump Body Assembly Note)
11 Gasket
12 Cam ring
(See N–19 Cam Ring Assembly Note)
13 Rotor
14 Vane
(See N–18 Vane Assembly Note)
15 Side plate
16 Power steering oil pump
49 F032 301
A6E66142010
CLIP
R
A6E66142008
A6E6316W013
To Next Page