R–14
REAR SUSPENSION
Bolt (Differential Front Side) Installation Note
1. Support the differential with a jack, and then
install the bolt.
2. Connect differential oil temperature sensor
connector and 4WD solenoid connector.
End Of Sie
TRAILING LINK REMOVAL/INSTALLATION (4WD)
A6E741628200201
Caution
• Performing the following procedures without first removing the ABS wheel-speed sensor may
possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the
following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate
place where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Inspect the rear wheel alignment.
(See R–9 REAR WHEEL ALIGNMENT (WGN).)
JACK
A6E74162011
To Next Page