Mazda Mazda6 - Page 808

FLOOR COVERING
S–27
S
FRONT FLOOR COVERING REMOVAL/INSTALLATION
A6E774868670201
WGN
1. Disconnect the negative battery cable.
2. Remove the front seats.
3. Remove the rear seat. (SeeS–29 REAR SEAT REMOVAL/INSTALLATION)
4. Remove the front scuff plates.
5. Remove the rear scuff plates.
6. Remove the console.
7. Remove the front side trims.
8. Remove the B-pillar lower trims.
9. Remove the lower anchor of the front seat belt installation bolts.
10. Remove the tire house trim.
11. Remove the fuel-filler lid opener bezel.
12. Remove the fasteners.
13. Remove the cap nuts.
14. Remove the clips.
15. Take the front floor covering off from the
passenger-side door opening.
16. Install in the reverse order of removal.
End Of Sie
FLOOR COVERING
FLOOR MAT
CLIP
CAP NUT
FASTENER
A6E77481101