S–28
SEAT BELT
REAR SIDE SEAT BELT REMOVAL/INSTALLATION
A6E775057730201
Caution
• The rear side seat belt for 4WD models is equipped with a silencer to reduce abnormal noise while
driving. If the silencer is not installed in the proper position, the push knob may not function
properly. When attaching the silencer, be sure to attach it in the correct area as shown below.
Note
• Rear side seat belts are built into the rear seat back. See rear seat disassembly/assembly, to remove/
install the rear side seat belt.
1. Peel off the backing of the double-sided adhesive tape.
2. Attach double-sided adhesive tape to the silencer as shown.
End Of Sie
REAR CENTER SEAT BELT REMOVAL/INSTALLATION
A6E775057730202
WGN
Caution
• The ELR has a spring that will unwind if the retractor's cover is removed. The spring cannot be
rewound by hand. If this occurs, the ELR will not work properly. Therefore, do not disassemble the
retractor.
1. Remove the headliner.
2. Remove the bolts.
3. Remove the rear center seat belt.
4. Install in the reverse order of removal.
End Of Sie
SEAT BELT
SILENCER
RETRACTOR
mm {in}
29—35
{1.2—1.3}
-3—3
{-0.1—0.1}
60
{2.3}
60
{2.3}
60
{2.3}
60
{2.3}
40
{1.5}
29—35
{1.2—1.3}
-3—3
{-0.1—0.1}
SILENCER
RETRACTOR
60
{2.3}
A6E77502101
39—78 N·m
{3.9—8.0 kgf·m, 29—57 ft·lbf}
REAR CENTER
SEAT BELT
BOLT
A6A7750W101
To Next Page