T–22
INTERIOR LIGHTING SYSTEM, WIPER AND WASHER
CARGO COMPARTMENT LIGHT INSPECTION
A6E811451441202
1. Remove the cargo compartment light. (See T–21 CARGO COMPARTMENT LIGHT REMOVAL/
INSTALLATION)
2. Inspect for continuity between the cargo
compartment light terminals using an ohmmeter.
• If not as specified, replace the cargo
compartment light.
End Of Sie
REAR WIPER MOTOR REMOVAL/INSTALLATION
A6E811667450201
1. Disconnect the negative battery cable.
2. Remove the rear wiper arm and blade. (See T–23 REAR WIPER ARM AND BLADE REMOVAL/
INSTALLATION.)
3. Remove the liftgate lower trim. (See S–24 LIFTGATE LOWER TRIM REMOVAL/INSTALLATION)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Adjust the rear wiper arm and blade. (See T–24
REAR WIPER ARM AND BLADE
ADJUSTMENT.)
End Of Sie
REAR WIPER MOTOR INSPECTION
A6E811667450202
1. Disconnect the negative battery cable.
2. Remove the liftgate lower trim. (See S–24 LIFTGATE LOWER TRIM REMOVAL/INSTALLATION)
3. Disconnect the rear wiper motor connector.
4. Connect battery positive voltage to the rear wiper motor terminal A, and ground the rear wiper motor terminal B
to a bare metal part of the vehicle.
A
B
OFF
DOOR
AB
**
A6J81141112
: Bulb
Switch position
DOOR
OFF
Terminal
B
A
A6A81141119
WIPER AND WASHER
1 Connector
2Bolt
3 Rear wiper motor
4 Outer bushing
N·m {kgf·cm, in·lbf}
4
3
1
2
3.92—6.86
{40.0—69.9,
34.8—60.6}
A6E81161110
To Next Page