WIPER AND WASHER
T–23
T
5. Verify that the rear wiper motor operates.
6. Disconnect the ground to the terminal B while the
rear wiper is operating.
7. Verify that the rear wiper stops in the park
position.
• If not as specified, replace the rear wiper
motor.
End Of Sie
REAR WIPER ARM AND BLADE REMOVAL/INSTALLATION
A6E811667420201
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Adjust the rear wiper arm and blade. (See T–24
REAR WIPER ARM AND BLADE
ADJUSTMENT)
AUTOSTOP
SWITCH
B
A
AB
M
A6E81161119
AUTOSTOP
SWITCH
B
A
M
AB
A6E81161120
1Cap
2Nut
3 Rear wiper arm (See T–24 Rear Wiper Arm
Installation Note)
4 Rear wiper blade
5 Rubber brush
N·m {kgf·cm, in·lbf}
5
3
1
2
5.89—9.81
{60.0—100, 52.1—86.7}
4
A6E81161112
To Next Page