Mazda Mazda6 - Page 836

WIPER AND WASHER
T–25
T
REAR WASHER NOZZLE ADJUSTMENT
A6E811667511202
1. Insert a needle or an equivalent tool into the spray
hole of the rear washer nozzle and adjust the
nozzle direction as shown.
End Of Sie
REAR WASHER HOSE REMOVAL/INSTALLATION
A6E811667470201
1. Disconnect the negative battery cable.
2. Remove the washer tank.
3. Partially peel off the right side mud guard.
4. Remove rear washer hose No.1 from the clips.
5. Remove rear washer hose No.1 and joint pipe A.
6. Remove joint pipe C from the body.
7. Remove the A-pillar trim.
8. Remove rear washer hose No.2 from clip A.
9. Remove clips B from the body.
10. Remove rear washer hose No.2 and joint pipes B.
11. Remove the D-pillar trim.
12. Remove the liftgate upper trim. (See S–23
LIFTGATE UPPER TRIM REMOVAL/
INSTALLATION)
mm {in}
GLASS
END LINE
13 {0.5}
7 {0.3}
28 {1.1}
GLASS
END LINE
A6E81161118
a
JOINT
PIPE A
REAR
WASHER
HOSE
NO.1
CLIP
CLIP
A6E81161148
a
JOINT
PIPE B
REAR
WASHER
HOSE
NO.2
CLIP B
CLIP A
JOINT PIPE
JOINT PIPE C
A6E81161149