Mercury BRAVO Service Manual

DRIVE SHAFT HOUSING SERVICE MANUAL NUMBER 28
Page 3A-34 90-863160 MAY 2000
5. Remove three O-rings from coupling end of U-joint shaft.
73922
a
b
a-O-ring Grooves
b-O-rings
Reassembly
CAUTION
Use only Quicksilver U-Joint and Gimbal Bearing Grease for lubricating U-joint
bearings. The use of any other lubricant will decrease the life of the bearings.
1. Reassemble U-joints as follows:
NOTE: When initially positioning crosses in yoke, be sure that grease fittings are facing to
coupler yoke (longer yoke).
WARNING
U-joint snap rings might accidentally be knocked off of the u-joint during installa-
tion. Wear safety glasses to avoid eye injury.
a. Standard Bravo U-Joint:Place U-joint bearing cups in yoke and start them on bear-
ing cross members. Install by using adaptor and pressing bearing through yoke and
onto cross members.
22181
a
b
c
d
e
a
a-Bearings
b-Yoke
c-Cross Members
d-Grease Fitting (Facing Longer Yoke)
e-Adaptor (91-38756)

Mercury BRAVO Specifications

General

Brand	Mercury
Model	BRAVO
Category	Engine
Language	English