BRAVO TWO GEAR HOUSING SERVICE MANUAL NUMBER 28
Page 3C-28 90-863160 MAY 2000
2. Inspect water passage seal for nicks, cuts or distortion. Replace if necessary.
22085
a
a-Speedometer Water Passage Seal
Water Passage Seal Replacement
1. Pry rubber seal out with a suitable tool.
22085
a
a-Rubber Seal
2. Lightly coat outside diameter of seal with 3-M adhesive (92-86166Q1) and install in
speedometer water passage bore. Ensure that top edge of seal is flush with gear
housing surface.
22085
a
a-Seal
To Next Page
Loading...
