REMOVAL, INSTALLATION AND ADJUSTMENTS
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 2A-29
Shift Cable Installation and Adjustment
NOTE: Using Adjustment Tool (91-12427), shift cables can be adjusted with or without the
sterndrive installed.
IMPORTANT: Front propeller on Bravo Three
sterndrive unit is always LH rotation and
rear propeller is always RH rotation. Shift cable end guide must move in direction
“A”, when control lever is placed in FORWARD gear position.
71656
A
BRAVO THREE
IMPORTANT: For Bravo One and Two
sterndrive unit propeller rotation is determined
by the shift cable installation in the remote control.
• If shift cable end guide moves in direction “A,” when control lever is placed in
Forward, remote control is setup for RIGHT HAND (RH) propeller rotation.
• If shift cable end guide moves in direction “B,” when control lever is placed in
Forward, remote control is setup for LEFT HAND (LH) propeller rotation.
22024
A
B
BRAVO ONE AND TWO
IMPORTANT: When installing shift cables, be sure that cables are routed in such a
way as to avoid sharp bends and/or contact with moving parts. DO NOT fasten any
items to shift cables.
1. Install shift cable into remote control. Refer to remote control manufacturer’s
instructions.
2. Loosen stud and move it to dimension, as shown. Retighten stud.
71657
b
a
a-Stud
b-3 In. (Center of Pivot Bolt to Center of Stud)
To Next Page
Loading...
Need help?
General