MAINTENANCE SERVICE MANUAL NUMBER 28
Page 1B-14 90-863160 MAY 2000
9. After paint has dried, spray entire sterndrive with Quicksilver Corrosion Guard. Refer to
SECTION 1B.
CAUTION
Store sterndrive unit in the full trim DOWN/IN position. U-joint bellows may develop
a “set” if unit is stored in raised position and may fail when unit is returned to ser-
vice.
10. If not already done, place sterndrive unit in the full trim DOWN/IN position.
11. Store battery. Refer to battery manufacturer’s instructions.
Power Package Recommissioning
Engine
Refer to appropriate Engine Service Manual.
Sterndrive
1. Perform ALL maintenance specified for completion “Annually” in “Maintenance Chart”
except items which were performed at the time of sterndrive layup.
2. Install fully-charged battery.
3. Clean battery cable clamps and terminals.
4. Reconnect battery cables. Be sure to tighten clamps securely.
5. Apply a thin coat of petroleum based grease to clamps and terminals to help retard
corrosion.
6. After recommissioning and starting engine, check steering system and shift control for
proper operation.
To Next Page
Loading...
