SERVICE PROCEDURES REQUIRING MINOR DISASSEMBLY
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 4A-33
Installation
CAUTION
The water hose in the following step is a preformed hose and must be installed with
the short end of the molded hose going into the gimbal housing. The hose must be
held in place while installing the tapered inserts. Failure to hold hose in place can
result in an overheat condition.
1. Position water hose as follows:
a. Gimbal Housing - hose edge must be flush with mounting surface.
22080
b
c
a
a-Gimbal Housing
b-Water Hose
c-Mounting Surface
b. Bell Housing - hose edge should protrude approximately 1/8 in. from edge of hole.
50322
c
a
b
a-Bell Housing
b-Water Hose
c-Hole
To Next Page
Loading...
