Mercury BRAVO - Page 256

BRAVO TWO GEAR HOUSING SERVICE MANUAL NUMBER 28
Page 3C-36 90-863160 MAY 2000
18. Using a dial-type lb-in. torque wrench, recheck the rolling preload by rotating drive shaft
with a slow steady motion (3-5 lb-in. [0.3-0.6 Nm]).
50410
a
b
a-Torque Wrench
b-Drive Shaft Adaptor
19. Install the original load ring, thrust ring and O-ring into the gear housing.
76883
b
a
c
a
b
c
d
a-Load Ring
b-Thrust Ring
c-O-Ring
d-Propeller Shaft
20. Install bearing carrier and tab washer. Align inner tab of tab washer with V-notch in
bearing retainer and outer tab with hole in gear housing.
a
b
a-Bearing Carrier
b-Tab Washer