BRAVO THREE GEAR HOUSING
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 3D-11
CAUTION
Clamp plate must be installed on gear housing when gear housing is separated
from drive shaft housing.
5. Install clamp plate, nuts and 4 washers on gear housing. Tighten securely.
72241
a
a-Clamp Plate (91-43559T)
CAUTION
Bearing carrier has a LEFT-HAND THREAD. Remove by turning CLOCKWISE.
6. Remove bearing carrier, by turning clockwise, using bearing carrier tool. Use a torch-
lamp to heat area where the carrier and housing meet to ease removal.
75895
a
b
a-Bearing Carrier Tool (91-805374--1)
b-Bearing Carrier
CAUTION
Outer propeller shaft bearing retainer has a LEFT- HAND THREAD. Remove by turn-
ing CLOCKWISE.
To Next Page
Loading...
