SERVICE PROCEDURES REQUIRING MAJOR DISASSEMBLY SERVICE MANUAL NUMBER 28
Page 4B-28 90-863160 MAY 2000
CAUTION
Bellows clamp may corrode if ground clip is not installed.
5. Position ground clip on bellows.
50383
a
a-Grounding Clip
6. Position U-joint bellows with TOP mark facing upwards and install U-joint bellows on
gimbal housing flange and position clamp as shown. Torque to 35 lb-in. (4 Nm).
IMPORTANT: Ensure that the bead on the inner mating surface of bellows is posi-
tioned in the groove in gimbal housing flange.
50383
a
b
a-U-joint Bellows
b-Hose Clamp
To Next Page
Loading...
