Mold-Masters Hot Runner - Page 220

12. Torque fasteners to specications detailed in General Assembly drawings.
13. Turn assembled unit over and attach actuator connection hose ttings
to the supply ports. Tighten to specications detailed in the General
Assembly drawing.
14. Attach gate seal and liner to nozzle. Tighten to specications detailed in
the General Assembly drawings. Attach nozzle thermocouple.
15. Attach valve bushing. Tighten to specications detailed in the General
Assembly drawing.
Accu-Line™ with Valve Bushing Assembly - continued
17-5ACCU-LINE™
Hot Runner User Manual
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.