Electra Elite IPK II Document Revision 3
System Hardware Manual 9 - 13
___________________________________________________________________________________
___________________________________________________________________________________
2. Plug the tabs marked A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked
C. Refer to Figure 9-14 Attaching the AD(A)-R Unit to the
Multiline Terminal.
3. Replace the base plate (or wall mount unit) and attach the line
cord. Refer to Section 3 Connecting a Multiline Terminal to the
System on page 8-15.
Figure 9-14 Attaching the AD(A)-R Unit to the Multiline Terminal
To Next Page
Loading...
