NEC ELECTRA ELITE IPK II - Page 424

___________________________________________________________________________________
9 - 18 Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
3. Install the ferrite core (provided with the unit) about two inches
from the line cord plug.
4. Connect the line cord to the unit, limiting the cable length from
the AP(A)/AP(R)-R Unit to the Single Line Telephone to a
maximum of 50 feet.
 When only installing the AP(R)-R Unit, plug the AC Adapter
(AC-2R/AC-3R Unit) power cord into the indicated AP(R)-R
Unit receptacle and connect it to a power source. Refer to
Figure 9-5 Connecting the AC Adapter to an Installed Adapter
on page 9-5.
5. Replace the base plate (or wall mount unit) and attach the line
cord. Refer to Section 3 Connecting a Multiline Terminal to the
System on page 8-15.
Figure 9-18 Installing the Ferrite Core on the AP(A)-R/
AP(R)-R Unit
2
”
AP(A)-R Unit
or
AP(R)-R Unit