NEC ELECTRA ELITE IPK II - Page 536

___________________________________________________________________________________
11 - 32 Installing Electra Elite Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3 Electra Elite IPK II
4. Remove the shaded base plate knockout shown on
Figure 11-39 Removing the Knockout.
5. Assemble the base plate and base cover.
6. As illustrated in Figure 11-40 Attaching the Base Plate to the
Wall, attach the base plate and base cover assembly (wide end
down) to the posts on the locally provided and installed wall
plate. Place locally provided screws in the nodes on the base
plate and secure the assembly to the wall.
Figure 11-39 Removing the Knockout
Figure 11-40 Attaching the Base Plate to the Wall
Posts
Nodes
Nodes