Electra Elite IPK II Document Revision 3
System Hardware Manual 11 - 33
___________________________________________________________________________________
___________________________________________________________________________________
7. Plug the line cord into the jack on the wall plate, wrap the extra
cord and secure it with a tie wrap, and lead the line cord out
through the groove in the side of the base unit.
8. When using a modular jack instead of a wall plate, plug the line
cord into the modular jack, wrap the extra cord and secure it
with a tie wrap, and lead the line cord out through the groove in
the side of the base unit.
Figure 11-41 Plugging in the Line Cord using a Wall Jack
Figure 11-42 Plugging in the Line Cord Using a Modular Jack
To Next Page
Loading...
