3 - 11
3 Operation and Test Run
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
3-1 Operation of Digital Operator
3
3-1-2 Key Operation Method
(2) Change to the extended function mode.
(3) Change the 3rd digit of the extended function parameter number.
• In the left-end digit (4th digit), “d” starts blinking.
• Press twice.
(“A001” is displayed.)
Note If you press when the left-end digit is
blinking, the selected value is canceled and it
returns to the display on which you pressed
and simultaneously.
• In the left-end digit, “A” is blinking.
• Press to enter the value blinking in the digit.
(“A” is entered.)
Note If you press when the digit is blinking, the
blink returns to the digit in which you entered the
previous value.
• In the 3rd digit, “0” is blinking.
• This “0” in the 3rd digit need not be changed, so
press to enter “0”.
To Next Page
Loading...
