3 Operation and Test Run
3 - 12
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
(4) Change the 2nd digit of the extended function parameter number.
(5) Change the 1st digit of the extended function parameter number.
• In the 2nd digit, “0” is blinking.
• Press twice.
(“A021” is displayed.)
• In the 2nd digit, “2” is blinking.
• Press to enter the value blinking in the digit.
(“2” is entered.)
Note If you press when the digit is blinking,
the blink returns to the digit in which you entered
the previous value.
• In the 1st digit, “1” is blinking.
• Press 8 times, or press twice.
(“A029” is displayed.)
• In the 1st digit, “9” is blinking.
• Press to enter the value blinking in the digit.
(“9” is entered.)
To Next Page
Loading...
