Omron RX Series - Page 163

4 - 17
4 Parameter List
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
4-3 Extended Function Mode
4
4-3-1 Group A: Standard Function Parameters
*1 The default data was changed from the previous model.
*2 The inverter operates at 4 to 19.8 mA when A101 and A102 are set to 0.00.
*3 The inverter operates at –9.8 to 9.8 V when A111 and A112 are set to 0.00.
\
A101 FI Start
Frequency
*2
0.00 to 99.9
100.0 to 400.0
0.00 Disabled Enabled Hz 7-24
A102
FI End Frequency
*2
0.00 Disabled Enabled Hz
A103 FI Start Ratio 0. to FI End Ratio (A104) 20. Disabled Enabled %
A104 FI End Ratio FV Start Ratio (A103) to 100. 100. Disabled Enabled %
A105 FI Start Selection 00: Use FI Start Frequency (A101)
01: 0 Hz
00 Disabled Enabled –
A111 FE Start
Frequency
*3
–400. to –100.
–99.9 to –00.0
0.00 to 99.99
100.0 to 400.0
0.00 Disabled Enabled Hz 7-25
A112 FE End
Frequency
*3
0.00 Disabled Enabled Hz
A113 FE Start Ratio –100. to FE End Ratio (A114) –100. Disabled Enabled %
A114 FE End Ratio FE Start Ratio (A113) to 100. 100. Disabled Enabled %
A131 Acceleration
Curve Parameter
01 (Small curve) to 10 (Large
curve)
02 Disabled Enabled – 7-57
A132 Deceleration
Curve Parameter
02 Disabled Enabled –
Parameter
No.
Function name Monitor or data range
Default
data
Changes during
operation
Unit Page
Normal b031 = 10
External frequency adjustment
Acceleration/
Deceleration