Omron RX Series - Page 334

7 Detailed Functions
7 - 8
High-function General-purpose Inverter 3G3RX-V1 User’s Manual (I578-E1)
Use this function to display the total power ON time of the inverter.
Use this function to display the temperature of the cooling fin that is built into the inverter.
Use this function to display the temperature of the thermistor connected between the control circuit
terminals TH and SC.
Use the thermistor PB-41E (manufactured by Shibaura Electronics Co., Ltd.).
Set the Thermistor Selection (b098) to 02 (NTC enabled).
Use this function to display the output status of each multi-function output terminal, based on whether
the corresponding 7-segment LED is lit or not lit.
This parameter can be set to display either of the following two:
• Life expectancy of main circuit board capacitor: 1
• Life expectancy of cooling fan: 2
Total Power ON Time Monitor [d017]
Parameter No. Function name Data Default data Unit
d017
Total Power ON Time
Monitor
0. to 9999. (Displayed in increments of
1 hour)
1000 to 9999 (10000 to 99990)
(Displayed in increments of 10 hours)
Γ100 to Γ999 (100000 to 999000)
(Displayed in increments of 1,000 hours)
–h
Fin Temperature Monitor [d018]
Parameter No. Function name Data Default data Unit
d018 Fin Temperature Monitor
–20.0 to 200.0: (Displayed in increments
of 0.1°C)
–°C
Motor Temperature Monitor [d019]
Parameter No. Function name Data Default data Unit
d019
Motor Temperature
Monitor
–20.0 to 200.0 (Displayed in increments
of 0.1°C)
–°C
Life Assessment Monitor [d022]
Life assessment
Normal
21