Omron ZW-7000 Series - Page 100

Displaying measured values in graphs
98
ZW-7000/5000
User's Manual
3 Select the trigger target.
Item Setting item Range Description
Trigger target I/O TIMING TIMING input signal (parallel I/O)
ZERO ZERO input signal (parallel I/O)
BUSY BUSY output signal (parallel I/O)
ENABLE ENABLE output signal (parallel I/O)
HIGH HIGH output signal (parallel I/O)
PASS PASS output signal (parallel I/O)
LOW LOW output signal (parallel I/O)
SYNC/TRIG SYNC input signal (parallel I/O)
SYNCFLG SYNCFLG output signal (parallel I/O)
TA SK_E NA BL E TASK_ENABLE output signal (parallel I/O)
LOGGING LOGGING input signal (parallel I/O)
LOGSTAT LOGSTAT output signal (parallel I/O)
LOGERR LOGERR output signal (parallel I/O)
STABILITY STABILITY output signal (parallel I/O)
RESET RESET output signal (Parallel I/O)
RESET output
sign
al (Par
allel I/O)
BUFFER_ERR
Turns ON when the dropping is occurred.
Dropping may be occur depending on the load factor of PC
when acquir
ement of data from ZW-7000 series. If these
dropping occurs, increase the arguments of logging.
Data slope
Data window (in)
Data window (out)
OUT1 Measurement results assigned to OUT1
OUT2 Measurement results assigned to OUT2
OUT3 Measurement results assigned to OUT3
OUT4 Measurement results assigned to OUT4