Omron ZW-7000 Series

To Next Page

To Previous Page

Saving measured values in a file

102

ZW-7000/5000

User's Manual

TriggerStartObject OUT1

OUT2

OUT3

OUT4

TIMING

ZERO

BUSY

ENABLE

HIGH

PAS S

LOW

TASKSTAT

LOGGING

LOGSTAT

LOGERR

STABILITY

RESET

BUFFER_ERR

Indicates the target data for the trigger start condition.

TriggerStartConditions EqualTo

NotEqualTo

AndMore

MoreThan

LessThan

AndLess

True (rising)

False (falling)

Indicates the trigger start condition.

EqualTo: =

NotEqualTo: ≠

AndMore: ≥

MoreThan: >

LessThan: <

AndLess: ≤

Tr ue: R i sin g

False: Falling

TriggerStartValue1 -999.999999 to 999.999999 mm Indicates the judgment value for the trigger start condition.

For data window (in/out), indicates the lower limit.

TriggerStartValue2 -999.999999 to 999.999999 mm Indicates the judgment value for the trigger start condition.

For data window (in/out), indicates the upper limit.

TriggerStartDelay -999.999999 to 999.999999 mm Indicates the delay time for the trigger start condition.

TriggerEnd Tru e

False

Indicates whether the trigger end condition is “Enabled” or

“Disabled”.

TriggerEndType IO

DataSlope

DataWindowIn

DataWindowOut

DataSize

Indicates the trigger end condition.

IO: I/O result

DataSlope: Data slope

DataWindowIn: Data window (in)

DataWindowOut: Data window (out)

DataSize: Number of data points

TriggerEndObject OUT1