Omron ZW-7000 Series - Setting the Output Conditions

Setting Measurement Items
ZW-7000/5000
User's Manual
215
Sensor controller operations
7
3
Sets the surface peak hold for TASK1 and the surface average hold for TASK2.
Setting Hold p.144
4 Press the / keys to select “TASK3” and press the
key.
5 Press the / keys to select “ITEM” and press the key.
6 Press the / keys to select “CALC” and press the key.
7 Select “PARAM.K” for the parameter type.
Press the / keys to select “PARAM.K” and press the
key.
8 Set the parameter to “0”.
The current setting value is displayed on the sub-display.
Press key to enter the editing mode, and the sub-display
blinks.
To edit numerical values, use the / / / keys.
Input “0”, then press the
key.
9 The decimal point is displayed.
Press the / key to move the decimal point.
Determine the decimal point and then press the
key.
10 Press the key to return to the previous menu.
11 Select “PARAMm” for the parameter type.
Press the / keys to select “PARAM.M” and press the
key.
12 Set the parameter to “1”.
The current setting value is displayed on the sub-display.
Press key to enter the editing mode, and the sub-display
blinks.
To edit numerical values, use the / / / keys.
Input “1”, then press the
key.
13 Press the key to return to the previous menu.
Steps Key operation Display Description