Omron ZW-7000 Series - Page 218

Setting Measurement Items
216
ZW-7000/5000
User's Manual
14 Select “PARAMn” for the parameter type.
Press the / keys to select “PARAM.N” and press the
key.
15 Set the parameter to “-1”.
The current setting value is displayed on the sub-display.
Press key to enter the editing mode, and the sub-display
blinks.
To edit numerical values, use the / / / keys.
Input “-1”, then press the
key.
16 Press the key to return to the previous menu.
17 Select “PARAM.X” for the parameter type.
Press the / keys to select “PARAM.X” and press the
key.
18 Set the parameter to “TASK1”.
The current setting value is displayed on the sub-display.
Press / key to enter editing mode and the sub-display blinks.
Select “TASK1” and press the
key.
19 Press the key to return to the previous menu.
20 Select “PARAMY” for the parameter type.
Press the / keys to select “PARAM.Y” and press the
key.
21 Set the parameter to “TASK2”.
The current setting value is displayed on the sub-display.
Press / key to enter editing mode and the sub-display blinks.
Select “TASK2” and press the
key.
22 Press the key for two seconds to enter the RUN mode.
Steps Key operation Display Description