Firmware Update
ZW-7000/5000
User's Manual
281
APPENDICES
9
1
From the personal computer's Start menu,
select [All Programs] - [OMRON] - [ZW] -
[Warp Engine ZW-7].
The [Warp Engine ZW-7] screen is displayed.
If Warp Engine ZW-7 fails to start up, a message
and then th
e following screen is displayed.
In this case, set the connection port.
2
If necessary, click [Full Update(Low speed)].
The model name and version of the currently
connecte
d Sensor Controller are displayed.
3
Click [Loading file], and select the file to
write to.
The model name and version of the Sensor
Con
trol
ler held in the file are displayed.
4
Click [Optimal Update(High speed)].
A message to confirm to start the update
appears
.
•When you click [Full Update(Low speed)], if the
“Different format” message is displayed, this
means that the format information for the
connected Sensor Controller and the specified
file do not match. If this happen, never continue
with the firmware update. The Sensor Controller
breaks down and no longer starts up properly.
•The update time can be shortened by selecting
[Optimal Update(High speed)], which will upd
ate
only necessar
y items. If you select [Full
Update(Low speed)], the update time will be
longer because all files will be updated.
Normally Optimal Update(High speed) is
recommended.
Important
To Next Page
Loading...
