Firmware Update
282
ZW-7000/5000
User's Manual
5
Check the content of the message, and click
[OK].
The firmware update is started.
A progress bar is displayed during update
pro
cessing. Wait for the successful end
message box to be displayed. (The update takes
several minutes to complete.)
• Errors may occur on the Sensor Controller
during updating, but just wait for the update to
complete.
• If the update progress bar stops midway or the
up
date does not end e
ven after ten minutes,
there is the possibility that the update has failed.
In this case, contact an OMRON branch or sales
of
fice about the fir
mware version before the
update and the one in the write file.
6
When the update is successfully completed,
a message appears. Click [OK].
7
Click [Finish] and exit Warp Engine ZW-7.
Important
To Next Page
Loading...
