Wiring
ZW-7000/5000
User's Manual
2
Installation and Connections
71
Parallel
input
ZERO input This is used to execute and clear a zero reset.
RESET input This resets all executing measurements and outputs.
While a RESET is being input, judgment output confor
ms to the non-measurement setting.
If this RESET input switches ON while the hold functio
n is used, the state in effect before
the hold function was set will be restored.
TIMING input This is a signal input from an external device that is used to
time the hold function with the
continuous measurement function enabled.
This is a signal input from an external device t
hat i
s used to time the measurement with the
trigger measurement function enabled.
LIGHT OFF input This LIGHT-OFF signal puts out the measurement LED.
While LIGHT-OFF is being input, the analog output, binary output, and judgment output
conform to
the non-measurement setting.
BANK_SEL input This is used for switching banks.
Specify the bank number in combinations of BANK_SEL1, 2 and 3.
However, if the bank mode is set to “JUDGMENT”,
the
bank cannot be switched at the
external signal input because the number of banks increases to 32.
LOGGING input This is used to start and end internal logging.
SYNC/TRIG input In the internal/PDO synchronized mode, this is a signal input (SYNC input) used in order
for t
he multiple ZWs to perform synchronization of measurements (image capture) at the
same time.
In the external synchronous measurement mode, this is a signal input (TRIG input) used in
order to decide the measurement (image capture) timing.
Class Name Description
Bank Number BANK_SEL1 BANK_SEL2 BANK_SEL3
BANK1 OFF OFF OFF
BANK2 ON OFF OFF
BANK3 OFF ON OFF
BANK4ONONOFF
BANK5 OFF OFF ON
BANK6 ON OFF ON
BANK7 OFF ON ON
BANK8ONONON
To Next Page
Loading...
