PIAGGIO Beverly 300 i.e. - Page 212

- Grease and fit a new dust gaiter.
- Fit the fork leg together with the stem on the fork
supporting clamp until it stops.
- Tighten the two screws to the prescribed torque
in the sequence indicated in the picture.
Locking torques (N*m)
Stem support clamp tightening screws 20 ÷ 25
- Refill the fork leg with the recommended product
to the prescribed amount.
Recommended products
AGIP FORK 7.5 W Oil for fork.
-
Characteristic
Oil quantity per stem
133 ± 3 cm³
- Bleed the hydraulic rod by actuating the stem re-
peatedly.
- Fit the spring into the stem.
Suspensions Beverly 300 i.e.
SUSP - 212