PIAGGIO Beverly 300 i.e. - Page 222

- Remove the full silent bloc bracket
- Hold the full silent bloc bracket in the clamp
- Using the appropriate tool, remove the silent bloc
from the bracket from the side corresponding to
the inside of the vehicle. This is to guarantee the
tool is centred properly on the support
Specific tooling
020271Y Tool for removing-fitting silent bloc
- Install a new silent bloc, making sure it aligns
properly with the reference tooth.
- Fit the silent blocs, making sure the chamfered
part of the silent bloc matches the chamfered part
of the bracket
- Using the appropriate tool, fit the silent bloc as
shown in the picture
Specific tooling
020271Y Tool for removing-fitting silent bloc
Suspensions Beverly 300 i.e.
SUSP - 222