QTech QSW-2900

send daemon is 60seconds.
【Command configuration mode】
Interface configuration mode, global configuration mode
【Usage】
This command is effective after 802.1x enables.
After 802.1x enables, configure according to the real situation.
【Example】
！Enable dot1x daemon on ethernet 0/5 with the period time of 20 seconds
QTECH(config-if-ethernet-0/5)#dot1x daemon time 20
！Configure dot1x daemon of ethernet 0/5 globally with the period time of 20
seconds
QTECH(config)#dot1x daemon time 20 interface ethernet 0/5
！Restore the default dot1x daemon configuration on ethernet 0/5
QTECH(config-if-fastethernet-5)#no dot1x daemon
8-25