！Restore the default dot1x daemon configuration of ethernet 0/5 globally
QTECH(config)#no dot1x daemon interface ethernet 0/5
8.3.3 dot1x eap-finish
After using dot1x eap-transfer command, 802.1 authentication message
encapsulated by EAP frame from user is sent to RADIUS server after transfering
to data frame encapsulated by other high level protocol.
After using dot1x eap-finish command,
dot1x eap-finish
【Default】
Use eap-finish way to transmit authentication message.
【Command configuration mode】
Global configuration mode
【Usage】
Choose dot1x eap-finish or dot1x eap-transfer command according to RADIUS
server configuration. If authentication message transmitting way is different from
8-26
To Next Page
Loading...
