RADIUS server authentication message receiving way, authentication fails.
【Example】
！Configure authentication message tramsitting to be eap-finish
QTECH(config)#dot1x eap-finish
【Related command 】
dot1x eap-transfer
8.3.4 dot1x eap-transfer
After using dot1x eap-transfer command, 802.1 authentication message
encapsulated by EAP frame from user is sent to RADIUS server without any
changes.
dot1x eap-transfer
【Default】
Use eap-finish way to transmit authentication message.
【Command configuration mode】
8-27
To Next Page
Loading...
