Global configuration mode
【Usage】
Use keyword “level-list” to display the specified level information in list. If the
“level-list” is not specified, the information of the higher level (The smaller the
level number is, the higher the level is.) and the equal level will be displayed.
Configure Trap host ip address for Syslog information to send to SNMP
Workstation by Trap message. (Refer to SNMP configuration)
【Example】
！Enable SNMP Agent logging
QTECH(config)#logging snmp-agent
！Configure filtrate rule to be permitting the information outputting of 0 to 3 levels
of all modules of SNMP Agent
QTECH(config)#logging snmp-agent 3
【Related command】
10-23
To Next Page
Loading...
