Use load application xmodem command to load application program by Xmodem
protocol.
load application xmodem
【Command configuration mode】
Privileged mode
【Usage】
Choose “send” -> “send file” in super terminal, and input full path and filename of
the file in filename dialog box, and choose Xmodem protocol in “protocol” , then
click 【send】.
Reboot the switch after successful download and run new application program.
【Example】
！Download application program by Xmodem protocol
QTECH#load application xmodem
12.2.4 load configuration ftp
12-10
To Next Page
