QTECH(config)# snmp-server enable traps gbn
12.5.16 snmp-server trap-source
Use snmp-server trap-source command to configure vlan interface of trap sending
source address. Use no snmp-server command to restore default trap sending
source address.
snmp-server trap-source { vlan-interface vlan-id | supervlan-interface
supervlan-id }
no snmp-server
【Parameter】
vlan-id is the vlan id of trap source-address. It ranges from 1 to 4094。
supervlan-id is the supervlan id of trap source-address. It ranges from 1 to 11.
【Default】
Trap source-address is defaulted to be output interface ip
【Command configuration mode】
Global configuration mode
12-68
To Next Page
Loading...
