【Usage】
System cannot be sure whether the vlan and supervlan of the input vlan-id or
supervlan-id are existed or not and whether they have interface and the ip address
of interfaces are also not sure.
【Example】
！Configure trap source-address to be the ip address of interface 1 of vlan
QTECH(config)# snmp-server trap-source vlan-interface 1
12.5.17 snmp-server engineID
Use snmp-server engineID command to configure local engine-id or recognizable
remote engine-id. Use no snmp-server engineID command to restore default local
engine-id or remove remote engine-id.
snmp-server engineID { local engineid-string | remote ip-address [udp-port
port-number] engineid-string }
no snmp-server engineID { local | remote ip-address [udp-port port-number] }
【Parameter】
engineid-string is an engine id that can only be recognized in a network. This
12-69
To Next Page
Loading...
