R&S ZVB - Page 225

R&S
®
ZVA / R&S
®
ZVB / R&S
®
ZVT GUI Reference
Trace Menu
Operating Manual 1145.1084.12 – 30 210
If the target value occurs at several stimulus values, the marker is placed to the search result with the
smallest stimulus value. The other measurement points with the same target value can be located using
the Target Search > function.
If the target is not found (e.g. because the active trace doesn't contain the target value), then the active
marker is not moved away from its original position.
Remote control:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute TARGet
CALCulate<Chn>:MARKer<Mk>:FUNCtion:RESult?
Target Search >
Activates the search to the right of the active marker position and sets the active marker to the defined
target value. The target search range is between the active marker position and the end (Stop) of the
search range. If the active trace contains no markers, a marker M 1 is created to indicate the search
result, and the target search range starts at the beginning (Start) of the search range.
If the target value occurs at several stimulus values, the marker is placed to the search result with the
smallest stimulus value (i.e. the one which is closest to the active marker position). The other
measurement points with the same target value can be located using Target Search > repeatedly.
If the target is not found (e.g. because the active trace doesn't contain the target value), then the active
marker is not moved away from its original position.
Remote control:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute RTARget
CALCulate<Chn>:MARKer<Mk>:FUNCtion:RESult?
< Target Search
Activates the search to the left of the active marker position and sets the active marker to the defined
target value. The target search range is between the Start value of the search range and the active marker
position. If the active trace contains no markers, a marker M 1 is created to indicate the search result, and
the target search range starts at the end (Stop) of the search range.
If the target value occurs at several stimulus values, the marker is placed to the search result with the
largest stimulus value (i.e. the one which is closest to the active marker position). The other measurement
points with the same target value can be located using Target Search > repeatedly.
If the target is not found (e.g. because the active trace doesn't contain the target value), then the active
marker is not moved away from its original position.
Remote control:
CALCulate<Chn>:MARKer<Mk>:FUNCtion:EXECute LTARget
CALCulate<Chn>:MARKer<Mk>:FUNCtion:RESult?
Target Value
Opens an dialog to select a marker for the target search and define the target value.