RL78/G1H CHAPTER 18 RF TRANSCEIVER
R01UH0575EJ0120 Rev. 1.20 Page 561 of 920
Dec 22, 2016
(3) Transmit/receive mode register 0 (BBTXRXMODE0)
This register sets the various types of the RF transmit/receive mode.
Set 1 to the CCA type bit when performing the CCA or ED.
Enables the selection whether to perform the automatic ACK reply action after the completion of receive by
using the automatic ACK mode enable bit.
Enables the setting to automatically transit to the receive mode after the completion of transmit by using the
automatic receive switch mode 0 enable bit. Enables the setting to automatically transit to the receive mode
after the completion of receive by using the automatic receive switch mode 1 enable bit. However, note that
the ACK reply takes precedence if all of the ACK reply conditions are satisfied when 1 (enable) is set to the
automatic ACK enable bit.
The battery life extension mode bit can set the battery life extension mode to enable for the branch condition
when performing the CSMA-CA process.
The BEACON mode bit can switch between Non-beacon/Beacon modes.
The intraPAN enable bit can set enable/disable by the intraPAN bit condition of the receive frame when the
address filter is enabled.
The BBTXRXMODE0 register consists of 8 bits and can be accessed (serial interface communication) in 8
bit unit.
Reset signal generation clears this register to 00H.
To Next Page
Loading...
