Renesas RL78/G1H - Page 603

RL78/G1H CHAPTER 18 RF TRANSCEIVER
R01UH0575EJ0120 Rev. 1.20 Page 585 of 920
Dec 22, 2016
(18) PAN identifier register 0 (BBPANID0)
This register is used to set the PAN identifier of the first address filter. It consists of 16 bits and is used to
detect the match with a received PAN identifier.
The BBPANID0 register is set by the serial interface in 8-bit units.
Reset signal generation sets this register to FFFFH.
Figure 18 - 24 PAN Identifier Register 0 (BBPANID0) Format
(19) Short address register 0 (BBSHORTAD0)
This register is used to set the short address of the first address filter. It consists of 16 bits and is used to
detect the match with a received PAN identifier.
The BBSHORTAD0 register is set by the serial interface in 8-bit units.
Reset signal generation sets this register to FFFFH.
Figure 18 - 25 Short Address Register 0 (BBSHORTAD0) Format
Address:
0015H, 0014H
After reset:
FFFFH
R/W
Symbol 15 14 13 12 11 10 9 8
BBPANID0
76543210
BBPANID0 PAN identifier
Address:
0017H, 0016H
After reset:
FFFFH
R/W
Symbol 15 14 13 12 11 10 9 8
BBSHORT
AD0
76543210
BBSHORTAD0 Short address