RL78/G1H APPENDIX A REVISION HISTORY
R01UH0575EJ0120 Rev. 1.20 Page 919 of 920
Dec 22, 2016
(8/9)
Edition Description Chapter
Rev.0.60 Change of Figure 18 - 70 Antenna Diversity Mode Register (BBANTDIV) Format CHAPTER 18 RF
TRANSCEIVERChange of description in 18.4.3 (60) Transmit data counter register (BBTXCOUNT)
Change of description in 18.4.3 (63) SFD setting register (BBSFD)
Change of description in 18.4.3 (68) Receive start timeout setting register
(BBANTTIMOUT)
Addition of 18.4.3(72) RF initial setting register (RFINI)
Deletion of 18.4.3(74) RF serial 2 control registers 0 to 2 (RFSER2REG0 to
RFSER2REG2)
Change of description in 18.4.3 (81) ANTSW control register (ANTSWCON)
Change of description in 18.4.3 (84) Port data register (GPIODATA)
Addition of 18.4.3 (86) SFD setting register 2 to 18.4.3 (91) Antenna diversity mode
register 2
Change of description in 18.5.1 Overview
Change of Table 18 - 9 Contents of Communication Format
Change of description in 18.6.4 Mode transition
Change of Figure 18 - 108 Wake Up Operation (for XTAL_RF Oscillator)
Change of Figure 18 - 109 Wake Up Operation (for REFCLKIN_RF External Clock)
Addition of Table 18 - 10 Pin Status
Change of Table 18 - 11 Description of Each State of Wake Up Operation
Addition of Table 18 - 12 Initial setting registers
Change of description in 18.6.4 (2) Power Down (transition from IDLE to SLEEP)
operation
Change of Table 18 - 13 Function State in Each RF Mode
Change of description in 18.7.1 Example of procedure for each operation
Change of description in 18.7.2 Example of procedure for function setting
Change of Table 18 - 15 to Table 18 - 20 Gain set (Frequency band identifier = 9)
Change of Figure 18 - 110 Relationship between Transmission Output Power and Gain
Set
Addition of Table 18 - 21 Gain set (Frequency band identifier = 4) to Figure 18 - 113
Relationship between Transmission Output Power and Gain Set (Frequency band
identifier = 8)
Addition of 18.7.2 (2) RF frequency setting for transmission
Addition of 18.7.2 (3) RF frequency setting for reception
Change of description in 18.7.3 Setting for each data rate
Addition of Table 18 - 61 To Table 18 - 69 Settings Required for Each Data Rate
Change of Table 19 - 1 Interrupt Source List (1/2) CHAPTER 19
INTERRUPT
FUNCTIONS
Change of Table 19 - 4, 19 - 5 Flags Corresponding to Interrupt Request Sources and
change, deletion of note 1 and note 2
Change of Figure 19 - 4, 19 - 5 Format of Interrupt Mask Flag Registers (MK0L, MK0H,
MK1L, MK1H, MK2L, MK2H)
To Next Page
Loading...
Need help?
General
