Instrument Function
R&S
®
SMBV100A
375Operating Manual 1176.8016.02 ─ 17
"On"
Corresponds to the default state of this parameter.
The signal calculation starts simultaneously with the external trigger
event but because of the instrument’s processing time the first sam-
ples are cut off and no signal is outputted. After elapsing of the inter-
nal processing time, the output signal is synchronous to the trigger
event.
"Off"
The signal output begins after elapsing of the processing time and
starts with sample 0, i.e. the complete signal is outputted.
This mode is recommended for triggering of short signal sequences
with signal duration comparable with the processing time of the
instrument.
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:EXTernal:SYNChronize:OUTPut
on page 655
External Delay Unit
Determine whatever the trigger delay is expressed in samples or directly defined as a
time period (seconds).
The parameter displays the delay converted in time.
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:DELay:UNIT on page 659
Trigger Delay
Sets trigger signal delay in symbols on external triggering.
Baseband Signal - Baseband Block
To Next Page
Loading...
