Instrument Function
R&S
®
SMBV100A
442Operating Manual 1176.8016.02 ─ 17
Carrier Table
Calls the table for configuring individual carriers. This configuration can be checked
with the aid of the "Carrier Graph".
The table displays the settings of all available carriers. Carriers in the On state are
highlighted. All carrier parameters can be edited in the table.
The Multi Carrier CW signal is only computed when the "Accept" button is pressed.
Whenever the table contains settings that have not yet been adopted with the "Accept"
button, the background is yellow.
Note: The phase/deg settings are only valid if optimization of the crest factor is dis-
abled ("Optimize Crest Factor" = Off).
"No."
This is the carrier index.
"State"
Switch a carrier on/off
"Power"
Sets the power of a carrier.
"Phase"
Sets the starting phase of a carrier.
"Accept"
Transfer the settings in the carrier table into the instrument.
Remote command:
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:STATe on page 696
[:SOURce<hw>]:BB:MCCW:CARRier:STATe on page 698
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:POWer on page 695
[:SOURce<hw>]:BB:MCCW:CARRier:POWer on page 697
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:PHASe on page 694
[:SOURce<hw>]:BB:MCCW:CARRier:PHASe on page 696
Carrier Graph
Calls a graphical representation of the chosen carrier configuration.
The carriers are on the X-axis and the colored bars represent those carriers which are
in the On state. Power is on the Y-axis, and the height of the bars corresponds to the
chosen power of each individual carrier.
Baseband Signal - Baseband Block
To Next Page
Loading...
