Instrument Function
R&S
®
SMBV100A
443Operating Manual 1176.8016.02 ─ 17
Remote command:
n.a.
Trigger/Marker
Calls the "Trigger/Marker" dialog (see "Trigger/Marker/Clock Settings" on page 443).
This dialog is used to select the trigger source, set the time delay on an external trigger
signal and configure the marker output signals.
Remote command:
n.a.
Clock
Calls the "Clock" dialog for selecting the clock source (see "Clock Settings"
on page 449).
Remote command:
n.a.
Trigger/Marker/Clock Settings
To access this dialog, select "Main Menu > Trigger/Marker".
The "Trigger In" section is where the trigger for the signal is set. Various parameters
will be provided for the settings, depending on which trigger source - internal or exter-
nal - is selected. The current status of signal generation ("Running" or "Stopped") is
indicated for all trigger modes.
The "Marker Mode" section is where the marker signals at the MARKER output con-
nectors are configured.
Baseband Signal - Baseband Block
To Next Page
Loading...
