Remote Control Commands
R&S
®
SMBV100A
613Operating Manual 1176.8016.02 ─ 17
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PATTern <Pattern>,
<BitCount>
The command defines the bit pattern used to generate the marker signal.
Parameters:
<Pattern> numeric
0 is marker off, 1 is marker on.
*RST: #H2
<BitCount> integer
Range: 1 to 64
*RST: 2
Example:
BB:ARB:TRIG:OUTP:MODE PATT
BB:ARB:TRIG:OUTP:PATT #H39FE0000,32
Manual operation: See "Marker Mode" on page 401
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:DIVider <Divider>
The command sets the divider for the pulsed marker signal in the setting
SOURce:BB:ARB:TRIGger:OUTPut:MODE PULSe. The pulse frequency is derived
by dividing the symbol rate by the divider.
Parameters:
<Divider> integer
Range: 2 to 1024
*RST: 2
Example:
BB:ARB:TRIG:OUTP2:PULS:DIV 2
sets the divider for the marker signal on output MARKER 2 to
the value 2.
BB:ARB:TRIG:OUTP2:FREQ?
queries the resulting pulse frequency of the marker signal
Response: 66 000
the resulting pulse frequency is 66 kHz.
Manual operation: See "Marker Mode" on page 401
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:FREQuency?
The command queries the pulse frequency of the pulsed marker signal in the setting
SOURce:BB:ARB:TRIGger:OUTPut:MODE PULSe. The pulse frequency is derived
by dividing the symbol rate by the divider. The divider is defined with com-
mand :BB:ARB:TRIG:OUTP:PULS:DIV.
Return values:
<Frequency> float
Increment: 0.001
SOURce Subsystem
To Next Page
Loading...
