Remote Control Commands
R&S
®
SMBV100A
658Operating Manual 1176.8016.02 ─ 17
Return values:
<RMode> STOP | RUN
RUN
The signal is generated. A trigger event occurred in the triggered
mode.
STOP
The signal is not generated. A trigger event did not occur in the
triggered modes, or signal generation was stopped by the com-
mand :BB:DM:TRIG:ARM:EXECute (armed trigger modes
only).
Example:
BB:DM:TRIG:SOUR EXT
sets external triggering
BB:DM:TRIG:MODE ARET
selects the Armed_Retrigger mode
BB:DM:TRIG:RMOD?
queries the current status of signal generation.
Response: RUN
the signal is generated, an external trigger was executed.
Usage: Query only
Manual operation: See "Running - Stopped" on page 373
[:SOURce<hw>]:BB:DM:TRIGger:SLENgth <SLength>
Defines the length of the signal sequence to be output in the "Single" trigger mode.
Parameters:
<SLength> integer
Range: 1 to 4294967295
*RST: 1000
Default unit: symbol
Example:
BB:DM:SEQ SING
sets trigger mode Single.
BB:DM:TRIG:SLEN 200
sets a sequence length of 200 symbols. 200 symbols will be out-
put after the next trigger event.
Manual operation: See "Trigger Signal Duration" on page 373
[:SOURce<hw>]:BB:DM:TRIGger:SOURce <Source>
Selects the trigger source.
SOURce Subsystem
To Next Page
Loading...
